Ultra Low Noise (4µVRMS) Single Rail Power Supply
Single Rail, 1.4V - 20.5V, 1A
- Input Voltage Range : +3VDC to +25VDC, 3VAC to 18VAC
- Output Voltage Noise : 4μVRMS (10 Hz, 100 kHz)
- Power-Supply Ripple Rejection:
– 82 dB (100 Hz)
– ≥ 55 dB (10 Hz, 10 MHz) - ANY-OUT™ Voltage Modes:
– User-Programmable Output via Solder pads on LDOVR PCB
– Output Voltage Range: +1.4 V to +20.5 V (0.1V step) - Output Current: 1A
- Dropout Voltage: 307 mV at 1A
- CMOS Logic Level-Compatible Enable Input, if enable is not required, tie EN to Vin (J4)
- External Sense Input - This pin
- must be connected to OUT, can be connected to the point of load to maximize accuracy, tie S+ to V+ if external connection not used (J5)
- Built-In Fixed Current Limit and Thermal Shutdown
- PCB size: 30x60mm
- Operating Temperature Range:–40°C to 125°C
Package Includes
1 x Fully completed and tested TPS7A4700 PCB
1 x Power supply PCB 30x60mm
4 x MBRS360T3G Diode Schottky 60V 4A ON SEMICONDUCTOR installed
1x 47uf 25V 10% D CASE SMD TANTALUM CAPACITORS T491X476K025AT KEMET installed
2 x WIMA SMD-PET SMD1812 0.1uF (0.1µF 0,1uF 100nF) 63V 10% Capacitor installed
1 x PANASONIC EEU-FC1E562 Cap Aluminum Lytic 5600uF 25V 20% (18 X 40mm)
1 x 5PIN angled headers for vertical mount
1 x 5PIN straight headers
1 x 3+2PIN straight header with
2 x 2PIN Jumper (Shunt) for Feedback and Enable control
1 x 5.08mm Pitch 2Pin PCB Mount Power Screw Terminal Block Connector
1 x 5.08mm Pitch 3Pin PCB Mount Power Screw Terminal Block Connector
4 x Plastic Nylon PCB Stand-off Spacer Hex M3 Male x M3 Female 10mm Length
1 x AAVID THERMALLOY 530613B00000G Heat Sink with Mounting Screw/Nut/Washer
1 x RC Snubber (WIMA MKS2 0.1uF + 180Ohm resistor)
1 x Silicon Rubber Pad Insulation Chip Heatsink Thermal insulator (26x20mm)
|