Dual Polarity LT3045/LT3094 Ultra Low Noise
Power Supply

Ultra Low Noise 0.8µV_RMS) Dual Polarity Power Supply
Positive Rail, 0V – 15V, 500mA
Negative Rail, 0V – -19.5V, 500mA

• Ultralow RMS Noise: 0.8µV_RMS (10Hz to 100kHz)
  
• Ultralow Spot Noise: 2nV/√Hz at 10kHz (2nV/√Hz at 10kHz for negative rail)
  
• Ultrahigh PSRR: 76dB at 1MHz (74dB at 1MHz)
  
• Output Current: 500mA per rail
  
• Wide Input Voltage Range: 1.8V to 20V
  
• Single Capacitor Improves Noise and PSRR
  
• 100µA SET Pin Current: ±1% Initial Accuracy
  
• Single Resistor Programs Output Voltage
  
• High Bandwidth: 1MHz
  
• Low Dropout Voltage: 260mV (235mV)
  
• Output Voltage Range: 0V to 15V (0V to -19.5V)
  
• PCB size: 60x60mm
  
• Operating Temperature Range:–40°C to 125°C

Package Includes

1 x Fully completed and tested LT3045 PCB with headers installed
1 x Fully completed and tested LT3094 PCB with headers installed
1 x Power supply PCB 60x60mm
8 x MBRS360T3G Diode Schottky 60V 4A ON SEMICONDUCTOR installed
2x 47uf 25V 10% D CASE SMD TANTALUM CAPACITORS T491X476K025AT KEMET installed
4 x WIMA SMD-PET SMD1812 0.1uF (0.1µF 0,1uF 100nF) 63V 10% Capacitor installed
2 x PANASONIC EEU-FC1E562 Cap Aluminum Lytic 5600uF 25V 20% (18 X 40mm)
4 x 5.08mm Pitch 2Pin PCB Mount Power Screw Terminal Block Connector
4 x Plastic Nylon PCB Stand-off Spacer Hex M3 Male x M3 Female 10mm Length
2 x AAVID THERMALLOY 530613B00000G Heat Sink with Mounting Screw/Nut/Washer
2 x RC Snubber (WIMA MKS2 0.1uF + 180Ohm resistor)
2 x Silicon Rubber Pad Insulation Chip Heatsink Thermal insulator (26x20mm)